Default-Metric - Dell Force10 Z9000 Reference Manual

prefix-list
list-name
ip-address
peer-group-name
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
Information

default-metric

Allows you to change the metric of redistributed routes to locally originated routes. Use this command with the
redistribute command.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number
Defaults 0
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The default-metric command in BGP sets the value of the BGP MULTI_EXIT_DISC (MED)
Information
attribute for redistributed routes only.
Related
bgp always-compare-med
Commands
redistribute
356
prefix-
(OPTIONAL) Enter the keyword prefix-list followed by the
name of an established prefix list. If the prefix list is not configured,
the default is permit (to allow all routes).
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
(OPTIONAL) Enter the name of the peer group to disable or enable all
routers within the peer group.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter a number as the metric to be assigned to routes from other
protocols. The range is 1 to 4294967295.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
– enables comparison of all BGP MED attributes.
– redistributes routes from other routing protocols into BGP.