Permit - Dell Force10 Z9000 Reference Manual

To delete a MAC access list, use the no mac access-list standard mac-list-
name command.
Parameters
mac-list-name
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
FTOS supports one ingress and one egress MAC ACL per interface.
Information
The number of entries allowed per ACL is hardware-dependent. For detailed specifications on
entries allowed per ACL, refer to your line card documentation.
Example
FTOS(conf)#mac-access-list access-list standard TestMAC
FTOS(config-std-macl)#?
deny
description
exit
no

permit

remark
seq
show
permit
Configure a filter to forward packets from a specific source MAC address.
C-Series, E-Series, S-Series, Z-Series
Syntax permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
Enter a text string as the name of the standard MAC access list (140
character maximum).
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only.
Specify packets to reject
List description
Exit from access-list configuration mode
Negate a command or set its defaults
Specify packets to forward
Specify access-list entry remark
Sequence numbers
Show Standard ACL configuration
• Use the no seq sequence-number command if you know the filter's sequence
number.
• Use the no permit {any | mac-source-address mac-source-
address-mask} command.
267