Dell Force10 Z9000 Reference Manual page 828

rp2
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip traffic summary shown in the Example below.
Information
Keyword
unknown protocol...
not a gateway...
security failures...
bad options...
Frags:
... reassembled
... timeouts
... too big
... couldn't fragment
...encapsulation
failed
Rcvd:
...short packets
828
(OPTIONAL) Enter the keyword rp2 to view only the statistics from
Route Processor 2.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
F10 Monitoring MIB available for the ip traffic statistics
command.
Introduced on the E-Series.
Definition
No receiver for these packets. Counts those packets whose protocol
type field is not recognized by FTOS.
Packets can not be routed; the host/network is unreachable.
Counts the number of received unicast/multicast packets that could
not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces do
not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
Unrecognized IP option on a received packet.
IP fragments received.
Number of IP fragments that were reassembled.
Number of times a timer expired on a reassembled queue.
Number of invalid IP fragments received.
Number of packets that could not be fragmented and forwarded.
Counts those packets which could not be forwarded due to ARP
resolution failure. FTOS sends an arp request prior to forwarding an
IP packet. If a reply is not received, FTOS repeats the request three
times. These packets are counted in encapsulation failed.
The number of bytes in the packet are too small.