Interface - Dell Force10 Z9000 Reference Manual

interface

Configure a physical interface on the switch.
C-Series, E-Series, S-Series, Z-Series
Syntax interface interface
Parameters
interface
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Usage
You cannot delete a physical interface.
Information
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an
interface in mode, ensure that the interface's configuration does not contain an IP address and
enter the switchport command.
Example
FTOS(conf)#interface gig 0/0
FTOS(conf-if-gi-0/0)#exit#
Related
interface loopback
Commands
interface null
interface port-channel
interface vlan
Enter one of the following keywords and slot/port or number
information:
• For 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For SONET interfaces, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
– configures a Loopback interface.
– configures a Null interface.
– configures a port channel.
– configures a VLAN.
699