Dell Force10 Z9000 Reference Manual page 733

Parameters
slot-number
Command Modes EXEC Privilege
Command History
Version 8.1.1.2
Version 8.1.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The Example below shows a line card that has an XFP interface. The type, medium,
Information wavelength, and receive power details are displayed. When a device that is not certified by
Dell Force10 is inserted, it might work, but its details might not be readable by FTOS and not
displayed here.
Example
FTOS#show interfaces linecard 0
TenGigabitEthernet 0/0 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:51:b2:d4
Pluggable media present, XFP type is 10GBASE-SR
Interface index is 33883138
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 20:16:29
Queueing strategy: fifo
Input Statistics:
pkts
Output Statistics:
--More--
Related
show interfaces
Commands
Enter a number for the line card slot. For the C-Series, the range is 0
to 7 for C300 and 0 to 3 for C150. For the E-Series, the range is 0 to 13
on the E1200/1200i, 0 to 6 on the E600/600i, and 0 to 5 on the E300.
Introduced support on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
Current address is 00:01:e8:51:b2:d4
Medium is MultiRate, Wavelength is 850.00nm
XFP receive power reading is -2.3538
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
– displays information on a specific physical interface or virtual interface.
733