Ip Igmp Snooping Last-Member-Query-Interval; Ip Igmp Snooping Mrouter - Dell Force10 Z9000 Reference Manual

Series, you must disable Layer 3 multicast (no ip multicast-routing) in order to
disable Layer 2 multicast flooding.

ip igmp snooping last-member-query-interval

The last member query interval is the maximum response time inserted into Group-Specific queries sent in response to
Group-Leave messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp snooping last-member-query-interval milliseconds
To return to the default value, use the no ip igmp snooping last-member-query-
interval command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command Modes INTERFACE VLAN
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage This last-member-query-interval is also the interval between successive Group-Specific Query
Information messages. Use this command to change the last-member-query interval.

ip igmp snooping mrouter

Statically configure a VLAN member port as a multicast router interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter
interface interface command.
Enter the interval in milliseconds. The range is 100 to 65535. The
default is 1000 milliseconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
683