Debug Isis; Debug Isis Adj-Packets - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

debug isis

Enable debugging for all IS-IS operations.

E-Series, S4810

To disable debugging of IS-IS, use the no debug isis command.

Command Modes

EXEC Privilege

Command History

Version 8.3.12.0

Entering debug isis enables all debugging parameters.

Use this command to display all debugging information in one output. To turn off debugging,

you normally enter separate no forms of each command. Enter the no debug isis

command to disable all debug messages for IS-IS at once.

Enable debugging on adjacency-related activity such as hello packets that are sent and received on IS-IS adjacencies.

E-Series, S4810

debug isis adj-packets [interface]

To turn off debugging, use the no debug isis adj-packets [interface]

Introduced on the S4810.

(OPTIONAL) Identifies the interface type slot/port as one of the

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For a SONET interface, enter the keyword sonet followed by

the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a VLAN, enter the keyword vlan followed by a number

from 1 to 4094.