Dell Force10 Z9000 Reference Manual page 621

SSH server version
Password Authentication
Hostbased Authentication
RSA Authentication
Vty
0
1
Command History
Version 9.1(0.0)
Version 8.3.12.0
Related
ip ssh server
Commands
show ip ssh
client-pub-keys
ssh
Open an SSH connection specifying the hostname, username, port number, and version of the SSH client.
FTOS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing. Inbound SSH supports
accessing the system through the management interface as well as through a physical Layer 3 interface.
NOTE: Some of the parameters in this command require licensing to access. For more information, contact your
Dell Force10 representative.
Z-Series, S4810
Syntax ssh {hostname|ipv4 address|ipv6 address} [-c encryption
cipher|-l username|-m HMAC alogorithm|-p port-number|-v {1|2}]
Parameters
hostname
vrf instance
ipv4 address
ipv6
addressprefix
-c encryption
cipher
: disabled.
Encryption HMAC
aes128-cbc hmac-sha1 10.11.8.13
aes128-cbc hmac-sha1 10.1.20.48
Introduced on Z9000.
Introduced on S4810.
Configure an SSH server.
Display the client-public keys.
(OPTIONAL) Enter the IP address or the hostname of the remote
device.
(OPTIONAL) E-Series Only:Enter the keyword vrf following by the VRF
Instance name to open a SSH connection to that instance.
(OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format.Range: /0 to /128
Note: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the following encryption cipher to use. (For v2 clients only.)
Without the FIPS mode enabled:
• 3des-cbc: Force ssh to use 3des-cbc encryption cipher.
: v2.
: enabled.
: disabled.
Remote IP
621