Dell Force10 Z9000 Reference Manual page 208

Parameters
interface
mac-address
Defaults none
Command Modes
Command History
Version 8.3.12.0
Version 8.4.2.1
Version 7.6.1.0
Usage
C-Series and S-Series only: Enter a supplicant's MAC address using the mac-address
Information
option to display information only on the 802.1X-enabled port to which the supplicant is
connected.
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X configuration
details (Port Authentication status, Untagged VLAN ID, Authentication PAE state, and Backend
state) are displayed for each supplicant, as shown in the Example below.
Example
FTOS#show dot1x int Gi 2/32
802.1x information on Gi 2/32:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts: 3
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Auth Type:
Auth PAE State:
208
Enter one of the following keywords and slot/port or number
information:
•
•
•
(Optional) MAC address of a supplicant.
• EXEC
• EXEC privilege
Introduced on the S4810.
Added the mac-address option on the C-Series and S-Series.
Introduced on the C-Series, E-Series, and S-Series.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Enable
AUTO
UNAUTHORIZED
Disable
None
Enable
10
Enable
11
30 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Initialize