Ip Tftp Source-Interface - Dell Force10 Z9000 Reference Manual

Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series
Related telnet
Commands

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.
C-Series, E-Series, S-Series, Z-Series
Syntax ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface
command.
Parameters
interface
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing
packets.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
120
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
– telnets to another device.
Enter the following keywords and slot/port or number information:
•
•
•
•
•
•
•
•
Introduced on the Z9000.
For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
For a Port Channel, enter the keyword port-channel
followed by a number. For the C-Series and S-Series, the
range is 1 to 128. For the E-Series, the range is 1 to 255 for
TeraScale and 1 to 512 for ExaScale.
For the SONET interfaces, enter the keyword sonet
followed by slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For VLAN interface, enter the keyword vlan followed by a
number from 1 to 4094.