Dell Force10 Z9000 Reference Manual page 143

linecard
linecard-voltage
PEM
RPM
SFM
Command Modes
Command History
Version 8.1.1.0
Version 7.8.1.0
Version 7.5.1.0
E-Series
Usage Fan speed is controlled by temperatures measured at the sensor located on the fan itself. The
Information fan temperatures shown with this command may not accurately reflect the temperature and
fan speed. For fan speed and temperature information, refer to your hardware installation
guide.
Example (E1200)
FTOS#show environment
-- Fan Status --
Tray Status Temp Volt Speed PEM0 PEM1 Fan1 Fan2 Fan3
-----------------------------------------------------
0 up < 50C 12-16V low/2100-2700 RPM up up up up up
1 up < 50C 12-16V low/2100-2700 RPM up up up up up
2 up < 50C 12-16V low/2100-2700 RPM up up up up up
3 up < 50C 12-16V low/2100-2700 RPM up up up up up
4 up < 50C 16-20V med/2700-3200 RPM up up up up up
5 up < 50C 12-16V low/2100-2700 RPM up up up up up
-- Power Entry Modules --
Bay Status
-----------------------------------------------------
0 absent or down
1 up
-- Line Card Environment Status --
Slot Status Temp PEM0 PEM1 Voltage
------------------------------------------------------
0 not present
1 not present
2 not present
3 not present
4 not present
Refer to the Examples for the show chassis, show command-
history, and show cpu-traffic-stats commands for a
comparison of output.
Enter the keyword linecard to view only information on line cards.
Enter the keyword linecard-voltage to view line card voltage
information.
Enter the keyword pem to view only information on power entry
modules.
Enter the keyword rpm to view only information on RPMs.
Enter the keyword sfm to view only information on SFMs.
NOTE: This option is supported on the E-Series only.
• EXEC
• EXEC Privildge
Introduced on the E-Series ExaScale.
Added temperature information for the C-Series fans (refer to the last
example.)
Introduced on the C-Series.
Original command.
143