Neighbor Remove-Private-As - Dell Force10 Z9000 Reference Manual

Parameters
ip-address
peer-group-name
number
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
You must configure your system to accept 4-byte formats before entering a 4-byte AS Number.
Information
If the number parameter is the same as the AS number used in the router bgp command,
the remote AS entry in the neighbor is considered an internal BGP peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
Related
router bgp
Commands
bgp four-octet-as-support

neighbor remove-private-as

Remove private AS numbers from the AS-PATH of outgoing updates.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name}
remove-private-as command.
Parameters
ip-address
peer-group-name
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Enter the IP address of the neighbor to enter the remote AS in its
routing table.
Enter the name of the peer group to enter the remote AS into routing
tables of all routers within the peer group.
Enter a number of the AS. The range is 0 to 65535 (2-byte) or 1 to
4294967295 (4-byte).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added 4-byte support.
– enters ROUTER BGP mode and configures routes in an AS.
– enables 4-byte support for the BGP process.
Enter the IP address of the neighbor to remove the private AS
numbers.
Enter the name of the peer group to remove the private AS numbers.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
373