Debug Cpu-Traffic-Stats - Dell Force10 Z9000 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
E-Series
Example
FTOS#configure
FTOS(conf)#

debug cpu-traffic-stats

Enable the collection of computer processor unit (CPU) traffic statistics.
C-Series, E-Series, S-Series, Z-Series
Syntax debug cpu-traffic-stats
To disable the debugging, use the no debug cpu-traffic-stats command.
Defaults Disabled
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Usage This command enables (and disables) the collection of CPU traffic statistics from the time this
Information command is executed (not from system boot). However, excessive traffic received by a CPU
automatically triggers (turn on) the collection of CPU traffic statics.
The following message is an indication that collection of CPU traffic is automatically turned on.
To view the traffic statistics, use the show cpu-traffic-stats command.
If excessive traffic is received by the CPU, traffic will be rate controlled.
Related show cpu-traffic-stats
Commands
104
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: This command must be enabled before the show cpu-traffic-stats
command displays traffic statistics. Dell Force10 recommends disabling debugging (no
debug cpu-traffic-stats) after troubleshooting is complete.
– displays the cpu traffic statistics.