Ip Igmp Access-Group - Dell Force10 Z9000 Reference Manual

Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage IGMP commands accept
Information This command displays packets for IGMP and IGMP snooping.

ip igmp access-group

Use this feature to specify access control for packets.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list
Defaults Not configured
Command Modes INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for Tera Scale.
• For SONET interfaces, enter the keyword sonet followed by
the slot/port information. This keyword is only available on
the E-Series and C-Series.
• For a 10–Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
only non-VLAN interfaces—specifying VLAN does not yield results.
Enter the name of the extended ACL (16 characters maximum).
interface-slot/port )
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced on E-Series.
669