Version 7.6.1.0
Version 7.4.1.0
Related
protocol lldp (Configuration)
Commands
show lldp neighbors
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Disabled.
Command Modes
CONFIGURATION (conf-lldp)
Introduced on the C-Series.
Introduced on the E-Series.
– enables LLDP globally.
– displays the LLDP neighbors.
Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is 2 to 10.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
interface -lldp)
963