Dell Force10 Z9000 Reference Manual page 807

Command Modes
Command History
Version 9.0.0.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show hosts command in the Example below.
Information
Field
Default domain...
Name/address
lookup...
Name servers are...
Host
Flags
TTL
Type
Address
Example
FTOS#show hosts
Default domain is not set
Name/address lookup uses static mappings
• EXEC
• EXEC Privilege
Added support for IPv6 addresses.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the domain name (if configured).
States if DNS is enabled on the system.
•
•
Lists the name servers, if configured.
Displays the host name assigned to the IP address.
Classifies the entry as one of the following:
•
•
Also included in the flag is an indication of the validity of the route:
•
•
•
Displays the amount of time until the entry ages out of the cache. For
dynamically learnt entries only.
Displays IP as the type of entry.
Displays the IP address(es) assigned to the host.
If DNS is enabled, the Name/Address lookup is domain
service.
If DNS is not enabled, the Name/Address lookup is static
mapping
perm - the entry was manually configured and will not time
out
temp - the entry was learned and will time out after 72 hours
of inactivity.
ok - the entry is valid.
ex - the entry expired.
?? - the entry is suspect.
807