Minimum-Links - Dell Force10 Z9000 Reference Manual

Example
FTOS(conf)#int port-channel 2
FTOS(conf-if-po-2)#
Related
channel-member
Commands
interface
interface loopback
interface null
interface vlan
shutdown

minimum-links

Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the LAG to be also in
"oper up" status.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax minimum-links number
Parameters
number
Defaults 1
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage
If you use this command to configure the minimum number of links in a LAG that must be in
Information
"oper up" status, the LAG must have at least that number of "oper up" links before it can be
declared as up. For example, if the required minimum is four, and only three are up, the LAG is
considered down.
756
– adds a physical interface to the LAG.
– configures a physical interface.
– configures a Loopback interface.
– configures a null interface.
– configures a VLAN.
– disables/enables the port channel.
Enter the number of links in a LAG that must be in "oper up" status.
The range is 1 to 16. The default is 1.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.