Boot System (S4810 And Z9000) - Dell Force10 Z9000 Reference Manual

Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 7.5.1.0
E-Series
Usage To display these changes in the show bootvar command output, save the running
Information configuration to the startup configuration (using the copy command) and reload the system.
Related
change bootflash-image
Commands
configuration.
boot system gateway
management subnet.

boot system (S4810 and Z9000)

Tell the system where to access the FTOS image used to boot the system.
Z-Series, S4810
Syntax
This command was deprecated in FTOS 8.3.12.0.
boot system {gateway ip address| stack-unit [{0-11 | 0-7]| all]
[default | primary {system {A: | B:} | tftp: | | secondary]}
To return to the default boot sequence, use the no boot system command.
Parameters
gateway
stack-unit
ip-address
0-11, 0-7, all
default
primary
secondary
tftp:
• on the external Flash, enter slot0:// followed by the
filename
• on a TFTP server, enter tftp://hostip/filepath
Introduced on C-Series
Original command
– changes the primary, secondary, or default boot image
– specifies the IP address of the default next-hop gateway for the
Enter the IP address of the default next-hop gateway for the
management subnet.
Enter the stack-unit number for the master switch.
Enter an IP address in dotted decimal format.
Enter the stack-unit number. The S4810 range is 0 to 11. The Z9000
range is 0 to 7.
Enter the keyword default to use the primary FTOS image.
Enter the keyword primary to use the primary FTOS image.
Enter the keyword secondary to use the primary FTOS image.
Enter the keyword TFTP: to retrieve the image from a TFTP server.
tftp://hostip/filepath.
61