Dell Force10 Z9000 Reference Manual page 55

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 Z9000:
Table of Contents

Advertisement

To enter ROUTER OSPF mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router ospf {process-id} command. The prompt changes to include (conf-router_ospf-id).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP mode by
using the router rip command.
ROUTER RIP Mode
You must use ROUTER RIP mode to configure RIP on the C-Series or E-Series. For more information, refer to
Information Protocol
(RIP).
To enter ROUTER RIP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router rip command. The prompt changes to include (conf-router_rip).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER OSPF mode by
using the router ospf command.
ROUTER ISIS Mode
You must use ROUTER ISIS mode to configure intermediate system to intermediate system (ISIS) on the E-Series. For
more information, refer to the Intermediate System to Intermediate System (IS-IS) chapter in the
Command Line Reference Guide .
To enter ROUTER ISIS mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router isis [tag] command. The prompt changes to include (conf-router_isis).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP mode by
using the router rip command.
ROUTER BGP Mode
You must use ROUTER BGP mode to configure Border Gateway Protocol (BGP) on the C-Series or E-Series. For more
information, refer to
Border Gateway Protocol IPv4
To enter ROUTER BGP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the router bgp as-number command. The prompt changes to include (conf-router_bgp).
You can return to CONFIGURATION mode by using the exit command.
VLT DOMAIN Mode
Use VLT DOMAIN mode to enable and configure the VLT domain protocol. For more information, refer to
Trunking
(VLT).
To enter VLT DOMAIN mode:
1. Verify that you are logged into CONFIGURATION mode.
(BGPv4).
Routing
E-Series FTOS
Virtual Link
55

Advertisement

Table of Contents
loading

Table of Contents