Advertise; Area-Password - Dell Force10 Z9000 Reference Manual

advertise

Leak routes between levels (distribute IP prefixes between Level 1 and Level 2 and vice versa).
E-Series, S4810
Syntax advertise {level1-into-level2 | level2-into-level1} prefix-
list-name
To return to the default, use the no advertise {level1-into-level2 | level2-
into-level1}[prefix-list-name] command.
Parameters
level1-into-level2
level2-into-level1
prefix-list-name
Defaults level1-into-level2 (Level 1 to Level 2 leaking enabled.)
Command Modes
Command History
Version 8.3.12.0
Version 7.5.1.0
Version 6.3.1.0
Usage
You cannot disable leaking from one level to another; however, you can regulate the rate flow
Information
from one level to another using an IP Prefix list. If you do not configure the IP Prefix list, all
routes are leaked.
You can find additional information in IETF RFC 2966,
Level IS-IS .

area-password

Configure a hash message authentication code (HMAC) password for an area.
E-Series, S4810
Syntax area-password [hmac-md5 | encryption-type] password
To delete a password, use the no area-password command.
856
Enter the keywords level1-into-level2 to advertise Level 1
routes into Level 2 LSPs. This is the default.
Enter the keywords level2-into-level1 to advertise Level 2
inter-area routes into Level 1 LSPs. This is described in RFC 2966.
Enter the name of a configured IP prefix list. Routes meeting the
criteria of the IP Prefix list are leaked.
for IPv4 )
• ROUTER ISIS (
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
Introduced on the S4810.
Added IPv6 ISIS support.
Version 6.3.1.0 Introduced
for IPv6 )
Domain-wide Prefix Distribution with Two-