Dell Force10 Z9000 Reference Manual page 901

Command Modes
Command History
Version 8.3.12.0
Usage
Use this command to confirm that the neighbor adjacencies are operating correctly. If you
Information
suspect that they are not, you can verify the specified area addresses of the routers by using
the show isis neighbors command.
The following describes the show isis neighbors command shown in the Example
below.
Field
System Id
Interface
State
Type
Priority
Uptime
Circuit Id
Example
The bold sections below identify that Multi-Topology IS-IS is enabled.
FTOS#show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:01 TEST.02
!
FTOS#show isis neighbors detail
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es):
49.0000.0001
•
•
•
• EXEC
• EXEC Privilege
Introduced on the S4810.
Description
The value that identifies a system in an area.
The interface, slot, and port in which the router was discovered.
The value providing status about the adjacency state. The range is
Up and Init.
This value displays the adjacency type (Layer 2, Layer 2 or both).
IS-IS priority advertised by the neighbor. The neighbor with highest
priority becomes the designated router for the interface.
Displays the interfaces uptime.
The neighbor's interpretation of the designated router for the
interface.
IP Address(es): 25.1.1.3*
MAC Address: 0000.0000.0000
Hold Time: 28
Link Local Address: fe80::201:e8ff:fe00:492c
Topology: IPv4 IPv6 , Common (IPv4 IPv6 )
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
901