Redistribute - Dell Force10 Z9000 Reference Manual

Parameters
ipv6-address
route-map
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 7.4.1.0
Usage The E-Series software resolves the network address configured by the network command
Information
with the routes in the main routing table to ensure that the networks are reachable via non-
BGP routes and non-default routes.
Related

redistribute

Commands
redistribute
Redistribute routes into BGP.
C-Series, E-Series
Syntax redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected
static
route-map
name
526
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
map-
(OPTIONAL) Enter the keywords
an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Introduced
– redistributes routes into BGP.
Enter the keyword connected to redistribute routes from physically
connected interfaces.
Enter the keyword static to redistribute manually configured
routes. These routes are treated as incomplete routes.
map-
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
route-map followed by the name of