Dell Force10 Z9000 Reference Manual page 760

byte pkts
1023-byte pkts
throttles
Rate info (interval 299 sec):
Time since last interface status change: 00:22:34
FTOS#
User Information The following describes the show interfaces port-channel brief command
shown in the Example below.
Field
LAG
Mode
Status
Uptime
Ports
(untitled)
Example
FTOS#sh int por 1 br
LAG Mode Status Uptime
1
FTOS#
Related
show lacp
Commands
760
41 64-byte pkts, 44502871 over 64-byte pkts, 249 over 127-
407 over 255-byte pkts, 3127 over 511-byte pkts, 606 over
Received 0 input symbol errors, 0 runts, 0 giants, 0
0 CRC, 0 IP Checksum, 0 overrun, 0 discarded
1218120 packets output, 100745130 bytes, 0 underruns
Output 5428 Multicasts, 4 Broadcasts, 1212688 Unicasts
1216142 IP Packets, 0 Vlans, 0 MPLS
0 throttles, 0 discarded
Input 01.50Mbits/sec, 2433 packets/sec
Output 00.02Mbits/sec,4 packets/sec
Description
Lists the port channel number.
Lists the mode:
•
•
Displays the status of the port channel.
•
•
Displays the age of the port channel in hours:minutes:seconds.
Lists the interfaces assigned to this port channel.
Displays the status of the physical interfaces (up or down).
•
•
L2 up 00:00:08
– displays the LACP matrix.
L3 - for Layer 3
L2 - for Layer 2
down - if the port channel is disabled (shutdown)
up - if the port channel is enabled (no shutdown)
In Layer 2 port channels, an * (asterisk) indicates which
interface is the primary port of the port channel. The primary
port sends out interface PDU.
In Layer 3 port channels, the primary port is not indicated.
Ports
Gi 3/0 (Up) *
Gi 3/1 (Down)
Gi 3/2 (Up)