Dell Force10 Z9000 Reference Manual page 231

count
byte
log
order
monitor
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.2.1.0
Version 8.1.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the Quality of Service chapter of the
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to the
When you use the log option, the CP processor logs details the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
You cannot include IP, TCP or UDP (Layer 3) filters in an ACL configured with ARP or Ether-type
(Layer 2) filters. Apply Layer 2 ACLs (ARP and Ether-type) to Layer 2 interfaces only.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
(OPTIONAL) Enter the keyword count to count packets processed
by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
(OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file.
(OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority) If
you did not use the keyword order, the ACLs have the lowest order
by default (255).
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the section "Flow-based Monitoring" in the Port
Monitoring chapter of the
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Added the monitor option.
Expanded to include the optional QoS order priority for the ACL
entry.
Port Monitoring
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
FTOS Configuration Guide .
FTOS Configuration Guide .
chapter.
231