Show Fefd - Dell Force10 Z9000 Reference Manual

show fefd

View FEFD status globally or on a specific interface.
E-Series, Z-Series, S4810
Syntax show fefd [interface]
Parameters
interface
Command Modes
Command History
Version 8.3.11.1
Version 8.3.12.0
Legacy E-Series
command.
Usage The following describes the show fefd command shown in the Example below.
Information
Field
Interface
Mode
Interval
State
(OPTIONAL) Enter the following keywords and slot/port or number
information:
•
•
•
•
•
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Description
Displays the interfaces type and number.
Displays the mode (aggressive or normal) or NA if the interface
contains fefd reset in its configuration.
Displays the interval between FEFD packets.
Displays the state of the interface and can be one of the following:
•
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
bi-directional (interface is up and connected and ing
neighbor's echoes).
err-disabled (only found when the FEFD mode is aggressive
and when the interface has not n its neighbor's echoes for 3
953