Version 8.3.1.0
Usage
Configuring this option retains the current best-path. When sessions are subsequently reset,
Information
the oldest received path is chosen as the best-path.
bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults
Enabled when a route reflector is configured.
Command Modes
ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
Route reflection to clients is not necessary if all client routers are fully meshed.
Information
Related
bgp cluster-id
Commands
neighbor route-reflector-client
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number}
command.
Parameters
ip-address
number
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History
Version 8.3.11.1
336
Introduced
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
– assigns an ID to a BGP cluster with two or more route reflectors.
– configures a route reflector and clients.
Enter an IP address as the route reflector cluster ID.
Enter a route reflector cluster ID as a number from 1 to 4294967295.
Introduced on the Z9000.