show interfaces
interface loopback
Configure a Loopback interface.
C-Series, E-Series, S-Series, Z-Series
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Example
FTOS(conf)#interface loopback 1655
FTOS(conf-if-lo-1655)#
Related
interface
Commands
interface null
interface port-channel
interface vlan
interface ManagementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
C-Series, E-Series, S-Series, S4810, Z9000
Syntax
interface ManagementEthernet slot/port
700
– displays the interface configuration.
Enter a number as the interface number. The range is 0 to 16383.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
– configures a physical interface.
– configures a Null interface.
– configures a port channel.
– configures a VLAN.