Related
interface
Commands
show ip interface
show interfaces
show interfaces transceiver
installed transceiver. The output also displays the transceiver's serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver's
serial number.
C-Series, E-Series, S-Series, Z-Series
Syntax
show interfaces [gigabitethernet slot/port | tengigabitethernet
slot/port | fortyGigE slot/port] transceiver
Parameters
gigabitethernet
tengigabitetherne
t
fortyGigE
Command Modes
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.5.4.0
Usage
The following describes the show interfaces transceiver command shown in the
Information
Example below.
740
– configures a physical interface on the switch.
– displays Layer 3 information about the interfaces.
– displays information on a specific physical interface or virtual interface.
– displays the physical status and operational status of an
For a 10/100/1000 interface, enter the keyword gigabitethernet
followed by the slot/port information.
For a 10G interface, enter the keyword tengigabitethernet
followed by the slot/port information.
For a 40G interface, enter the keyword fortyGigE followed by the
slot/port information.
•
EXEC
•
EXEC Privilege
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Output augmented with diagnostic data for pluggable media.
Removed three fields in the output: Vendor Name, Vendor OUI, and
Vendor PN.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.