Dell Force10 Z9000 Reference Manual page 411

peer-group-name
detail
summary
Command Modes
Command History
Version 8.3.11.1
Version 8.3.8.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp peer-group command shown in the Example
Information
below.
Line beginning with:
Peer-group
Administratively shut
BGP version
Minimum time
For address family
BGP neighbor
Number of peers
Peer-group
members:
Example (S4810)
FTOS#show ip bgp peer-group
Peer-group pg1
Number of peers in this group 4
(OPTIONAL) Enter the name of a peer group to view information about
that peer group only.
(OPTIONAL) Enter the keyword detail to view detailed status
information of the peers in that peer group.
(OPTIONAL) Enter the keyword summary to view status information
of the peers in that peer group. The output is the same as that found
in the show ip bgp summary command.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Added the add-path option to the S4810. Output on the S4810
shows the ADDPATH parameters.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the peer group's name.
Displays the peer group's status if the peer group is not enabled. If
you enable the peer group, this line is not displayed.
Displays the BGP version supported.
Displays the time interval between BGP advertisements.
Displays IPv4 Unicast as the address family.
Displays the name of the BGP neighbor.
Displays the number of peers currently configured for this peer
group.
Lists the IP addresses of the peers in the peer group. If the address
is outbound optimized, an * is displayed next to the IP address.
BGP version 4
Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP neighbor is pg1
Update packing has 4_OCTECT_AS support enabled
411