cam-acl
Allocate CAM for IPv4 and IPv6 ACLs.
C-Series, S-Series, Z-Series
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number,
ipv4qos number l2qos number, l2pt number ipmacacl number
ecfmacl number [vman-qos | vman-dual-qos number}openflow {4|8}
Parameters
default
l2acl
ipv4acl
ipv6acl
ipv4qos
l2qos
l2pt
ipmacacl
ecfmacl
[vman-qos |
vman-dual-qos
number
Command Modes
CONFIGURATION
Command History
Version 9.1.(0.0)
Version 8.3.11.1
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
Usage
You must save the new CAM settings to the startup-config (write-mem or copy run
Information
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated. The ipv4acl profile range is 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
548
Use the default CAM profile settings and set the CAM as follows:
•
•
•
•
•
•
number
Allocate space to each CAM region.
number
Enter the CAM profile name followed by the amount of CAM space to
number ,
be allotted. The total space allocated must equal 13. The ipv6acl
number
range must be a factor of 2.
number ,
Enter 4 or 8 for the number of OpenFlow FP blocks.
number
number
•
number
•
Added support for OpenFlow.
Introduced on the Z9000.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
OpenFlow: 0 (disabled)
4: Creates 242 entries for use by the OpenFlow controller (256
total entries minus the 14 entries reserved for internal
functionality)
8: Creates 498 entries for use by the OpenFlow controller (512
total entries minus the 14 entries reserved for internal
functionality)