Show Capture Bgp-Pdu Neighbor - Dell Force10 Z9000 Reference Manual

Version 7.7.1.0
Usage At least one interface must be in Layer 3 mode for the router bgp command to be
Information
accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
Example
FTOS(conf)#router bgp 3
FTOS(conf-router_bgp)#

show capture bgp-pdu neighbor

Display BGP packet capture information for an IPv4 address on the system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show capture bgp-pdu neighbor ipv4-address
Parameters
ipv4-address
Command Modes EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0
Example
FTOS(conf-router_bgp)#show capture bgp-pdu neighbor 20.20.20.2
Incoming packet capture enabled for BGP neighbor 20.20.20.2
Available buffer size 40958758, 26 packet(s) captured using
680 bytes
00000000
00000000 419ef06c 00000000
41af92c0
00000000 00000000 00000000
[. . .]
Outgoing packet capture enabled for BGP neighbor 20.20.20.2
Available buffer size 40958758, 27 packet(s) captured using
562 bytes
386
Introduced on the C-Series.
Enter the IPv4 address (in dotted decimal format) of the BGP address
to display packet information for that address.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
PDU[1] : len 101, captured 00:34:51 ago
ffffffff ffffffff ffffffff ffffffff 00650100 00000013
00000000 00000000 00000000 00000000 0181a1e4 0181a25c
00000000 00000001 0181a1e4 0181a25c 41af9400 00000000
PDU[2] : len 19, captured 00:34:51 ago
ffffffff ffffffff ffffffff ffffffff 00130400
PDU[3] : len 19, captured 00:34:51 ago
ffffffff ffffffff ffffffff ffffffff 00130400
PDU[1] : len 41, captured 00:34:52 ago