Permit Ether-Type - Dell Force10 Z9000 Reference Manual

Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the "Quality of Service" chapter of the
When you use the log option, the CP processor logs details about the packets that match.
Depending on how many packets match the log entry and at what rate, the CP may become
busy as it has to log these packets' details.
The monitor option is relevant in the context of flow-based monitoring only. For more
information, refer to
You cannot include IP, TCP, or UDP filters in an ACL configured with ARP filters.

permit ether-type

Configure a filter that allows traffic with specified types of Ethernet packets. This command is supported only on 12-port
GE line cards with SFP optics. For specifications, refer to your line card documentation.
E-Series
Syntax permit ether-type protocol-type-number {destination-mac-address
mac-address-mask | any} vlan vlan-id {source-mac-address mac-
address-mask | any} [count [byte] | log] [order] [monitor]
To remove this filter, you have two choices:
Parameters
protocol-type-
number
destination-mac-
address mac-
address-mask
any
vlan
Port Monitoring.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
• Use the no seq sequence-number command if you know the filter's sequence
number.
• Use the no permit ether-type protocol-type-number
{destination-mac-address mac-address-mask | any} vlan
vlan-id {source-mac-address mac-address-mask | any}
command.
Enter a number from 600 to FFF as the specific Ethernet type traffic to
drop.
Enter a MAC address and mask in the nn:nn:nn:nn:nn format.
For the MAC address mask, specify which bits in the MAC address
must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
Enter the keyword any to match and drop specific Ethernet traffic on
the interface.
vlan-id
Enter the keyword vlan and then enter the VLAN ID to filter traffic
associated with a specific VLAN. The range is 1 to 4094 and 1 to 2094
for ExaScale (you can use IDs 1 to 4094). To filter all VLAN traffic
specify VLAN 1.
FTOS Configuration Guide .
245