Dell Force10 Z9000 Reference Manual page 145

Parameters
all
fan
stack-unit
pem
Command Modes
Command History
Version 8.3.11.1
Version 7.8.1.0
Version 7.6.1.0
Usage The example below shows the output of the show environment fan command as it
Information appears prior to FTOS 7.8.1.0.
Example (all)
FTOS#show environment all
-- Fan Status --
-------------------------------------------
Unit TrayStatus Fan0 Fan1 Fan2 Fan3 Fan4 Fan5
0 up up up up up up up
-- Power Supplies --
Unit Bay Status Type
--------------------------------------------
0 0 up AC
0 1 absent
-- Unit Environment Status --
Unit Status Temp Voltage
--------------------------------------------
0* online 50C ok
* Management Unit
-- Fan Status --
Unit Status Speed Fan1 Fan2 Fan3 Fan4 Fan5 Fan6 Serial Num
Version
---------------------------------------------
1 up high up up up up up up 1234 1
Example (fan)
FTOS#show environment fan
-- Fan Status --
---------------------------------------------
Unit TrayStatus Fan0 Fan1 Fan2 Fan3 Fan4 Fan5
0 up up up up up up up
Example (pem)
FTOS#show environment pem
-- Power Supplies --
Unit Bay Status Type
Enter the keyword all to view all components.
Enter the keyword fan to view information on the fans. The output of
this command is chassis dependent.
unit-id
Enter the keyword stack-unit followed by the unit-id to display
information on a specific stack member. The range is 0 to 1.
Enter the keyword pem to view only information on power entry
modules.
• EXEC
• EXEC Privildge
Introduced on the Z9000.
The output of the show environment fan command for the S-
Series is changed to display fan speeds instead of showing the fan
status as up or down.
Introduced for the S-Series. S-Series options and output differ from
the C-Series/E-Series version.
145