Defaults
Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage
If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its
Information
configuration takes precedence over the neighbor next-hop-self (C-, E-, and
S-Series) command.
neighbor peer-group (assigning peers)
Allows you to assign one peer to a existing peer group.
C-Series, E-Series
Syntax
neighbor ipv6-address peer-group peer-group-name
To delete a peer from a peer group, use the no neighbor ipv6-address peer-
group peer-group-name command.
Parameters
ipv6-address
peer-group
group-name
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage
You can assign up to 64 peers to one peer group.
Information
When you add a peer to a peer group, it inherits all the peer group's configured parameters. A
peer cannot become part of a peer group if any of the following commands are configured on
the peer:
Introduced on the E-Series ExaScale.
Introduced
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-
Enter the keywords peer-group followed by the name of a
configured peer group. The maximum is 16 characters.
Introduced on the E-Series ExaScale.
Introduced
•
neighbor advertisement-interval
•
neighbor distribute-list
•
neighbor next-hop-self: C- E- S-Series
•
neighbor route-map
•
neighbor route-reflector-client
•
neighbor send-community
487