Match Tag - Dell Force10 Z9000 Reference Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
match metric

match tag

match tag
Configure a filter to redistribute only routes that match a specified tag value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match tag tag-value
To remove a match, use the no match tag command.
Parameters
tag-value
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– redistributes routes that match the next-hop interface.
– redistributes routes that match an IP address.
– redistributes routes that match the next-hop IP address.
– redistributes routes that match routes advertised by other routers.
– redistributes routes that match a specific metric.
– redistributes routes that match a specific tag.
Enter a value as the tag on which to match. The range is zero (0) to
4294967295.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
291