Enable Xfp-Power-Updates - Dell Force10 Z9000 Reference Manual

Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.11.4
Version 8.3.10.0
Usage Use this command to enable polling and to configure the polling frequency.
Information

enable xfp-power-updates

Enable 10–gigabit small form-factor pluggable (XFP) power updates for SNMP.
C-Series, E-Series, S-Series
Syntax enable xfp-power-updates interval seconds
Parameters
interval
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 8.3.11.4
Version 8.3.10.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Usage The chassis MIB contains the entry chSysXfpRecvPower in the chSysPortTable
Information
table. Periodically, IFA polls the XFP power for each of the ports and sends the values to IFM
where it is cached.
Use this command to enable polling and to configure the polling frequency.
108
Introduced on the Z9000 to replace the enable xfp-power-
updates command.
Replacement command for the S4810 only. Replaces the enable
xfp-power-updates command.
seconds
Enter the keyword interval followed by the polling interval in
seconds. Range: 120 to 6000 seconds. Default: 300 seconds (5
minutes).
Deprecated command for Z9000 only. Replaced by the enable
optic-info-update interval command to update
information on temperature and power monitoring in the SNMP MIB.
Deprecated command for the S4810 only. Replaced by the enable
optic-info-update interval command to update
information on temperature and power monitoring in the SNMP MIB.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.