interface
interface-type
vlan
count
Command Modes
Command History
Version 8.3.11.1
Version 8.3.12.0
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
The following describes the show mac-address-table command shown in the Example
Information
below.
Column Heading
VlanId
Mac Address
932
•
•
•
•
•
(OPTIONAL) Instead of entering the keyword interface followed
by the interface type, slot and port information, as above, you can
enter the interface type, followed by just a slot number.
vlan-id
(OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
(OPTIONAL) Enter the keyword count, followed optionally, by an
interface or VLAN ID, to display total or interface-specific static
addresses, dynamic addresses, and MAC addresses in use.
•
EXEC
•
EXEC Privilege
Introduced on the Z9000.
Updated the output.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.