Neighbor Activate; Neighbor Add-Path - Dell Force10 Z9000 Reference Manual

neighbor activate

This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address Family
Identifier/Subsequent Address Family Identifier).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name]
activate command.
Parameters
ip-address
peer-group-name
activate
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage By default, when you create a neighbor/peer group configuration in the Router BGP context,
Information this enables IPv4/Unicast AFI/SAFI. When you use activate in the new context, the
neighbor/peer group enables for AFI/SAFI.

neighbor add-path

This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
Z-Series, S4810
Syntax neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
Parameters
ip-address
peer-group-name
send
receive
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword activate to enable the neighbor/peer group in
the new AFI/SAFI.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword send to indicate that the system will send multiple
paths to peers.
Enter the keyword receive to indicate that the system will accept
multiple paths from peers.
359