Dell Force10 Z9000 Reference Manual page 393

Parameters
ipv4 unicast
community-list-
name
exact-match
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The show ip bgp community-list command without any parameters lists BGP routes
Information
matching the Community List and the output is the same as for the show ip bgp command
output.
The following describes the show ip bgp community-list pass command shown in
the Example below.
Field
Network
Next Hop
Metric
LocPrf
Weight
Path
Example
FTOS#show ip bgp community-list pass
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
FTOS#
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
Enter the name of a configured IP community list (max 16 characters).
Enter the keyword for an exact match of the communities.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the destination network prefix of each BGP route.
Displays the next hop address of the BGP router. If 0.0.0.0 is listed in
this column, then local routes exist in the routing table.
Displays the BGP route's metric, if assigned.
Displays the BGP LOCAL_PREF attribute for the route.
Displays the route's weight.
Lists all the ASs the route passed through to reach the destination
network.
Next Hop Metric LocPrf Weight Path
393