Show Config (From Interface Range Mode); Show Interfaces - Dell Force10 Z9000 Reference Manual

show config (from INTERFACE RANGE mode)

Display the bulk configured interfaces (interface range).
C-Series, E-Series, S-Series, Z-Series
Syntax show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Example
FTOS(conf)#interface range gigabitethernet 1/1 - 2
FTOS(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
!
interface GigabitEthernet 1/2
FTOS(conf-if-range-gi-1/1-2)#

show interfaces

Display information on a specific physical interface or virtual interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show interfaces interface
Parameters
interface
720
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no ip address
switchport
no shutdown
no ip address
switchport
no shutdown
Enter one of the following keywords and slot/port or number
information:
•
•
•
For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.