Debug Lldp Interface - Dell Force10 Z9000 Reference Manual

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

Version 7.6.1.0

Version 7.4.1.0

debug lldp interface

Enable LLDP debugging to display timer events, neighbor additions or deletions, and other information about incoming

and outgoing packets.

C-Series, E-Series, S-Series, Z-Series, S4810

debug lldp interface {interface | all}{events | packet {brief |

detail} {tx | rx | both}}

To disable debugging, use the no debug lldp interface {interface | all}

{events} {packet {brief | detail} {tx | rx | both}} command.

Introduced on the C-Series.

Introduced on the E-Series.

Enter the following keywords and slot/port or number information:

For a Fast Ethernet interface, enter the keyword

FastEthernet followed by the slot/ port information.

For a 1-Gigabit Ethernet interface, enter the keyword

gigabitEthernet followed by the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

tenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

NOTE: The FastEthernet option is not supported on the S-

(OPTIONAL) Enter the keyword all to display information on all

(OPTIONAL) Enter the keyword events to display major events such

as timer events.

(OPTIONAL) Enter the keyword packet to display information

regarding packets coming in or going out.

(OPTIONAL) Enter the keyword brief to display brief packet

information.

(OPTIONAL) Enter the keyword detail to display detailed packet

information.

(OPTIONAL) Enter the keyword tx to display transmit only packet

information.

(OPTIONAL) Enter the keyword rx to display receive only packet

information.