Dell Force10 Z9000 Reference Manual page 239

destination
mask
count
byte
log
order
monitor
fragments
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
Version 8.3.11.1
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage
The order option is relevant in the context of the Policy QoS feature only. For more
Information
information, refer to the Quality of Service chapter of the
Enter the IP address of the network or host to which the packets are
sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or non-
contiguous.
(OPTIONAL) Enter the keyword count to count packets processed
by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by
the filter.
(OPTIONAL, E-Series only) Enter the keyword log to have the
information kept in an ACL log file. Supported on Jumbo-enabled line
cards only.
(OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is 0 to 254 (where 0 is the highest priority
and 254 is the lowest; lower order numbers have a higher priority) If
you did not use the keyword order, the ACLs have the lowest order
by default (255).
(OPTIONAL) Enter the keyword monitor when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the section "Flow-based Monitoring" in the Port
FTOS Configuration Guide .
Monitoring chapter of the
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the Z9000.
Added the keyword dscp.
Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for non-contiguous mask and added the monitor
option. Deprecated the keyword established.
Expanded to include the optional QoS order priority for the ACL
entry.
FTOS Configuration Guide .
239