Stop Jumpstart - Dell Force10 Z9000 Reference Manual

stop jumpstart

Stop the switch from reloading in BMP mode to prevent an infinite loop.
Z-Series, S4810
Syntax stop jumpstart
Defaults none
Command Modes CONFIGURATION
Command History
Version 9.1(0.0)
Version 8.3.11.4
Version 8.3.10.1
Usage Use the stop jumpstart command on a switch running BMP 2.0 if the switch enters a
Information
loop while reloading in jumpstart mode; loop occurs when the switch is continuously trying to
contact a DHCP server and a DHCP server is not found. The stop jumpstart command
stops the switch from connecting to the DHCP server. After you use the stop jumpstart
command, the next default reload type is a normal reload. This is indicated in the show
reload-type command.
Related reload type
Commands
NOTE: This command has been deprecated. It has been replaced by the disable-bmp
command.
Deprecated command. Replaced by the disable-bmp command.
Introduced on the Z9000.
Introduced for the S4810.
– configures the reload mode as normal or jumpstart (BMP).
545