Dell Force10 Z9000 Reference Manual page 664

Ftos command line reference guide for the z9000 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 Z9000:

Table of Contents

enablepwdignore

stconfigignore

Command Modes

Command History

Version 8.3.11.1

After setting the values, save the variables that you set using the save_env command before

rebooting to ensure the variables are saved.

The IP address and the MAC addresses must be a standard IPv4 and MAC address,

respectively.

grub>set ipaddr=10.11.196.143

grub>set primary_boot='f10boot tftp://10.11.200.241/

z9000_image'

grub>set stconfigignore=true

grub>set secondary_boot = 'f10boot flash0'

grub>save_env ipaddr

grub>save_env primary_boot

grub>save_env stconfigignore

grub>save_env secondary_boot

set default_boot='f10boot flash0 | flash1 |

tftp://ip-addr/file'

Set the MAC address of the unit.

Set the baud rate of the console connection.

To reload the system software with or without the Enable Password

set. Use the following syntax:

set enablepwdignore=true|false

To enable/disable applying the startup-confg during bootup. Use the

following syntax:

set stconfigignmore=true|false

Introduced on the Z9000.

NOTE: The enablepwdignore and stconfigignore GRUB commands, when set

as true are applicable only for the first time when the unit boots up. The next time the

unit boots up, these variables are set to False and must be set to True in GRUB.