Show Ip Bgp Filter-List - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
To view the total number of COMMUNITY attributes found, use the show ip bgp
Information
summary command. The text line above the route table states the number of COMMUNITY
attributes found.
The show ip bgp community command without any parameters lists BGP routes with at
least one BGP community attribute and the output is the same as for the show ip bgp
command output.

show ip bgp filter-list

View the routes that match the filter lists.
C-Series, E-Series, S-Series, S-Series, S4810
Syntax show ip bgp [ipv4 unicast] filter-list as-path-name
Parameters
ipv4 unicast
as-path-name
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp filter-list hello command shown in
Information
the Example below.
Field
Path source codes
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
Enter the name of an AS-PATH.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Lists the path sources shown to the right of the last AS number in the
Path column:
• i = internal route entry
397