Match Metric - Dell Force10 Z9000 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop

match metric

match route-type
match tag
match metric
Configure a filter to match on a specified value.
C-Series, E-Series, S-Series, Z-Series
Syntax match metric metric-value
To delete a value, use the no match metric [metric-value] command.
Parameters
metric-value
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
match route-type
match tag
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– redistributes routes that match the next-hop interface.
– redistributes routes that match an IP address.
– redistributes routes that match the next-hop IP address.
– redistributes routes that match a specific metric.
– redistributes routes that match a route type.
– redistributes routes that match a specific tag.
Enter a value to match. The range is zero (0)–4294967295.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– redistributes routes that match the next-hop interface.
– redistributes routes that match an IP address.
– redistributes routes that match the next-hop IP address.
– redistributes routes that match routes advertised by other routers.
– redistributes routes that match a route type.
– redistributes routes that match a specific tag.
289