Duplex (10/100 Interfaces) - Dell Force10 Z9000 Reference Manual

Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage This command applies only to the Management interface on the route processor modules
Information (RPMs).
Related
interface ManagementEthernet
Commands
Primary or Standby RPM).
duplex (Management)
management route
forwarding router.
speed (Management interface)

duplex (10/100 Interfaces)

Configure duplex mode on any physical interfaces where the speed is set to 10/100.
C-Series, E-Series. S-Series, Z-Series, S4810
Syntax duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half
full
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
694
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Documentation modified—added
duplex (10/100 Interfaces).
– configures the Management port on the system (either the
– sets the mode of the Management interface.
– configures a static route that points to the Management interface or a
– sets the speed on the Management interface.
Enter the keyword half to set the physical interface to transmit only
in one direction.
Enter the keyword full to set the physical interface to transmit in
both directions.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
Management to distinguish from