Show Ip Bgp Community-List; Show Ip Bgp Dampened-Paths - Dell Force10 Z9000 Reference Manual

Usage
To view the total number of COMMUNITY attributes found, use the show ip bgp
Information
summary command. The text line above the route table states the number of COMMUNITY
attributes found.
The show ip bgp community command without any parameters lists BGP routes with at
least one BGP community attribute and the output is the same as for the show ip bgp
command output.

show ip bgp community-list

View routes that are affected by a specific community list.
C-Series, E-Series TeraScale, S-Series
Syntax show ip bgp ipv4 multicast community-list community-list-name
Parameters
community-list-
name
Command Modes
Command History
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0

show ip bgp dampened-paths

View BGP routes that are dampened (non-active).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip bgp [ipv4 unicast] dampened-paths
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
The following describes the show ip bgp damp command shown in the Example below.
Information
436
Enter the name of a configured IP community list (max 16 characters).
• EXEC
• EXEC Privilege
Introduced on the S-Series.
Introduced on the C-Series.
Introduced IPv6 MGBP on the E-Series.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.