Ipg (Gigabit Ethernet Interfaces); Ipg (10 Gigabit Ethernet Interfaces) - Dell Force10 Z9000 Reference Manual

interface port-channel
show vlan
shutdown
tagged
untagged
openflow of-instance

ipg (Gigabit Ethernet interfaces)

Set the inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
E-Series
Syntax ipg 8
To return to the default setting, use the no ipg command.
Parameters
8
Defaults 12 bytes
Command Mode INTERFACE
Command History
Version 8.2.1.0
Version 8.1.1.0
pre-Version
6.1.1.0
Usage For 1-Gigabit Ethernet interfaces only.
Information

ipg (10 Gigabit Ethernet interfaces)

Set the inter-packet gap for traffic on 10–Gigabit Ethernet interface.
E-Series
Syntax ipg {ieee-802.3ae | shrink}
To return to the default of averaging the IPG, use the no ipg {shrink |
ieee-802.3ae} command.
708
– configures a port channel group.
– displays the current VLAN configuration on the switch.
– disables/enables the VLAN.
– adds a Layer 2 interface to a VLAN as a tagged interface.
– adds a Layer 2 interface to a VLAN as an untagged interface.
— creates or modifies an OpenFlow instance.
Enter the keyword 8 to set the IPG to 8 bytes.
Support for 4093 VLANs on E-Series ExaScale. Prior releases
supported 2094.
Introduced on E-Series ExaScale.
Introduced for E-Series
NOTE: This command is an EtherScale-only command.