Revision - Dell Force10 Z9000 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable MSTP
Information
globally on the switch, enter the no disable command while in MULTIPLE SPANNING TREE
mode.
For more information about the multiple spanning tree protocol, refer to the
Guide .
Example
FTOS(conf)#protocol spanning-tree mstp
FTOS(config-mstp)#no disable
Related disable
Commands

revision

The revision number for the multiple spanning tree configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax revision range
To return to the default values, use the no revision command.
Parameters
range
Defaults 0
Command Modes MULTIPLE SPANNING TREE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage For two MSTP switches to be within the same MST region, the switches must share the same
Information revision number.
998
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– disables multiple spanning tree.
Enter the revision number for the MST configuration. The range is 0 to
65535. The default is 0.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
FTOS Configuration